Removing Glued Down Hardwood From Plywood

Removing those same hardwood flooring boards is another matter.

Removing glued down hardwood from plywood. Pull all remaining nails out of the floor. Having set the blade for the depth of the flooring cut a line about 15 18 away from the wall itself across the entire room. Try to keep the cut in the seams lines. Sand and refinish wood floor after the adhesive has been removed allow ample time for the floor to dry.

One method to remove the glued down wood floors on concrete without power tools. This will become our starter area for the tear out. Pull all the exposed nails from the loose plywood. Our flooring is about 3 4 inches thick so i set the blade depth about 3 4 inches deep so that the blade cut through the hardwood floors without cutting into the plywood subfloor.

Use a hammer to drive them back through the plywood and then pull them out from the top with the hammer. It is almost always easier to remove engineered flooring from the tongue side rather than the grooved edge of the board. Remove the flooring with a hand held floor scraper after putting on work gloves. Gluing down hardwood flooring is a complicated process requiring you to painstakingly place each plank perfectly lined up to provide a beautiful surface that can last decades.

Check that the tongue side of the board is facing toward you. Once the floor is completely dry rent a floor sander and edger to sand the floor smooth and remove any traces of adhesive. Need 2 long crow bars. Once done repeat with another cut in another seam.

Finally vacuum up all the dust wipe the floor down and finish with several coats of polyurethane. The wedges are placed where the planks meet. How to remove hardwood flooring first set the blade depth on your circular saw. Pull up on the.